Programming a MS13E2 X10 PIR Sensor

18 Apr

This again is mostly for my reference.

After removing the little plastic cap and screw you have access to 2 buttons, <HOUSE> and <UNIT>.

Setting the House Code:
Press and hold the <HOUSE> button.
Then press the <HOUSE> button the desired number of times:

  1. A
  2. B
  3. C etc…

Setting the Unit Code:
Press and hold the <UNIT> button.
Then press the <UNIT> button the desired number of times:

  1. 1
  2. 2
  3. 3 etc…

Setting the Daytime Detection:
Press the <UNIT> button (green light will show) then press and hold the <HOUSE> button
Press the <HOUSE> button the desired number of times:

  1. Daytime PIR On, Sensor Off
  2. Daytime PIR Off, Sensor Off
  3. Daytime PIR On, Sensor On
  4. Daytime PIR Off, Sensor On

Setting the Delay:
Press the <HOUSE> button (green light will show) then press and hold the <UNIT> button
Press the <UNIT> button the desired number of times:

  1. 1min
  2. 2mins
  3. 4mins
  4. 8mins etc…

For all these settings, on the last press to set the number, hold the button down until the red LED starts flashing to indicate the new setting.